Motion sensor light bulb download#

Measure the diameter of the Fresnel lens part (white color part).

Make a hole on the side wall of the enclosure, round enough to insert the socket.

The type of LED sheet is up to the user, but the voltage should be 12V.

Number of LEDs can be varied as per requirement, limiting the current drawn up to 1Amp.Make sure that the holes for screwing are not covered and make a hole on one of the side walls of the box to insert LED input terminals.that is on the top cover of the switch box. The LED sheet used here comes with double sided sticking tape.Use instant sticking glue to fix it (if necessary) The adapter must be placed in such a way that the contact pins should be in parallel with the wall of the enclosure.Placement should be decided as per the space available in the enclosure after placing the AC/DC adapter.Limit the corner parts of the square and cut away to insert the adapter.On the bottom of the enclosure, draw a square whose length of a side is equal to the diameter measured.Open the Batten adapter and measure the diameter of the threaded portion.

Motion sensor light bulb download#

Note 2: For more information, download data sheet of PIR sensor: Fixing the adapter: Note 1: Read our tutorial on Interfacing PIR Sensor to Arduino to learn more about PIR Sensor. Re-Triggering Mode: When the sensor detects motion, it sets the output to High until a set time and resets the output to Low, but if it detects motion during its output High state, it again triggers the timer making it to count from zero.

Normal Mode: When the sensor detects motion, it sets output to High until set time and re-sets output to Low, independent of the movements during the output HIGH time. If sensor with input voltage capability of 12V is not in your reach, use LM 7805 regulator for sensor part. The mode is selected by the jumper provided on the rear side of the sensor PCB. This is a motion detector, which detects movement of human beings and triggers its output to High state. Old jewellery box/Similar (2”X1.5”X1.5” )Approx It’s possible to wire directly without any mounting. However, this type of mounting is up to your will and wish. This is achieved by using a 3.5 mm stereo jack and its socket. The mounting of the sensor is done in such a way that the angular position of the sensor can be adjusted, so that, the original position of the batten holder does not affect the sensing of human passage. This simple adapter converts normal bulb into a smart Bulb, with the help of a PIR sensor. If you are not willing to re-wire your home for smart lighting or not interested in spending a huge amount of money for the smart lighting system, then this DIY project is for you.